Today I continue working on two tables, each with curly maple tops. Because the tops are 2 in. thick, I routed the undersides with a very large 45° chamfering bit to make them appear lighter, and I used a wide, flat, tapered shim double stick taped to the surface, supporting the router to cut deeper and hence thinner along the front edge at the center of the board. This is intended to add interest, stopping the top from being just a thick, massive, square ended chunk of lovely wood. Perhaps you can see in the photo by observing the front edge, how the routing provides a sense of greater thickness at the ends, making it appear less heavy at the center. This is experimental. You can tell me now whether you think it works, or wait unti...